What is Z-BRICK? Z-BRICK, developed in 1956, is the original veneer facing brick which can be easily installed by the homeowner or contractor to create a traditional masonry appearance without the weight, labor or cost of masonry. You can do it yourself!
What are Z-BRICK products made of?
Z-BRICK products are made of several non-combustible mineral-based materials and do not contain plastic, plaster or synthetics. How are Z-BRICK products installed?
Z-BRICK products are installed simply by applying a thin coat of Z-MENT and pressing the stone or brick pieces into place. The adhesive also serves as the mortar line. To what can Z-BRICK products be applied?
Z-BRICK products may be applied to any rigid, clean, dry non-flaking substrate such as plaster, plasterboard, concrete, plywood, cement, cement backer board, brick or cement block. Surfaces must be clean, dry, and free of flaking matter. All questionable surfaces - such as painted plaster or pre-finished paneling - MUST be scored deeply over the entire surface to ensure a good bond. All old wallpaper must be removed. Can Z-BRICK products be applied to the exterior of our home?
Exterior siding is one of the best uses. Z-BRICK products are weatherproof and require no maintenance or refinishing. Exterior applications MUST be sealed with two coats of Z-SEALER. Why is Z-SEALER necessary?
We strongly recommend that once Z-Ment Adhesive is dry to the touch - an acrylic-base sealer will make the product as maintenance free as possible. If, after sealing, the installation becomes soiled, it can be cleaned by spraying with a garden hose. Periodic resealing is recommended. Two coats should be applied behind stoves and sinks to help protect the installation to allow for easier cleaning. Are Z-BRICK products guaranteed?
Zygrove Corporation stands behind its products but only if Z-MENT and Z-SEALER are used and the manufacturer's instructions are properly followed. Z-BRICK products are guaranteed for 50 years when installed according to the manufacturer's specifications. How much adhesive is needed for an installation?
One gallon of Z-MENT covers approximately 16-20 sq ft or roughly four cartons of Z-BRICK / or five cartons of Z-BRICK stone. How much sealer is needed for an installation?
One quart of Z-Sealer will cover about 80 square feet, one coat. How can the coverage be stretched - to keep the cost down?
The width of the mortar line can be increased. Normal brick spacing is 1/2" to 5/8" but a wider joint could be used. How can Z-BRICK or GRAYSTONE be cut?
Z-BRICK and GRAYSTONE is easy to cut and shape. With a tungsten carbide blade, a shallow cut can be made across the surface of a piece of brick or stone. Then, the pieces can be tapped lightly - but sharply - directly behind the saw cut and the piece will snap clean along the line. A stroke or two with a rasp or coarse file will remove any rough edges. Can Z-BRICK products be used as floor brick?
Z-BRICK products are designed primarily as a wall cover. The brick and adhesive have been used satisfactorily as a covering for a fireplace hearth where there is very light foot traffic. However, Z-BRICK products are not recommended for areas exposed to normal foot traffic. Can Z-BRICK products be used in the bathroom?
When applied with Z-MENT adhesive, Z-BRICK products can be used in the bathroom. However, when applying brick and adhesive in the bathroom, the adhesive should not be exposed to any moisture before it is allowed to thoroughly cure. After the adhesive has thoroughly cured, it is recommended that several coats of sealer be applied to help protect the installation and allow for easier cleaning. The adhesive contains a fungicide which will help prevent the growth of mold. However, if Z-BRICK products are installed in a shower area, "soap scum" will accumulate on the brick just like that which is seen on ceramic tile, and the installation will have to be scrubbed occasionally to keep it clean.
